10" Automatic Round Damper; Flex To Rigit Adapter; Rigid Pipe Hose Adapter - Ultratec G3000 Operator's Manual

10" Automatic Round Damper

The 10" Automatic Round Damper (ARD) is an inline damper that will open or close to allow or prevent fog from
flowing down a run of 10" ducting. When using with a 'Y' connector as illustrated, fog may be diverted down
either or both branches of ducting. The unit operated using 110 VAC and may be field set to open or close upon
receiving power. Two leads are provided for power connection. The ARD is constructed of galvanized steel and fits
inside 10" rigid pipe and held with sheet metal screws or inside a 10" flex pipe and held with a worm gear clamp.
DMX control can be obtained by using a DMX relay control like the CLF 2944 LSG DMX Interface 110 Volt. The
ARD may also be used as a cost effective back flow prevention device.

Flex to Rigit Adapter

The CLF 9033 10" Adaptor (Flex Hose to Rigid) is used when a connection between flex hose and rigid pipe is
needed.

Rigid Pipe Hose Adapter

CLF 2957 LSG MKII Rigid Pipe Hose Adaptor is used with the LSG Touring Road Case model and extends the LSG
fog output to outside the road case where pipe connections can be made easier.
15
www.ultratecfx.com