Round Floor Pocket - Ultratec G3000 Operator's Manual

The pressure builder is a very important
component in achieving the proper LSG
Mark II operating pressure. We can monitor
this operating pressure by observing the
pressure gauge located on the top of the
Liquid CO2 Tank.
Ideally the operating pressure of the Liquid
CO2 Tank is 310 - 330 p.s.i.g. This is
achieved by opening the pressure builder
valve prior to operating the LSG Mark II.
TECH TIP: Building the pressure to the
proper level may take up to an hour so it is
suggested that the Pressure Builder valve be fully opened one to three hours before use.
NOTE: The Liquid CO2 Tank is equipped with a pressure relief valve that is fixed to open at 350 p.s.i.g.
The pressure relief valve is in place to ensure the internal Liquid CO2 Tank pressure does not exceed 350
p.s.i.g. As you approach the ideal operating pressure the relief valve may open slightly and release CO2
gas. Although this is sometimes noisy this is no cause for alarm, simply close the pressure builder valve
by turning clockwise.

Round Floor Pocket

The Round Floor Pocket is designed to be flush mounted into the stage floor and is pneumatically operated and
electrically controlled. The Floor Pocket connects to either our 10" Rigid or 10" Flex Hose. DMX control can be
obtained by using a DMX relay control like the CLF 2944 LSG DMX Interface (110 Volt). The Floor Pocket may be
mounted as shown in the illustration.
1. Layout a 10 ¾" diameter and a 12 ¾" diameter hole on
the same centers onto the stage floor.
2. Cut a through hole into the stage on the 10 ¾" diameter
markings.
3. Route away approximately a 5/16" recess in the remaining
12 ¾" diameter layout for the recess.
4. Insert the floor pocket into the hole cut into stage noting
the orientation of the fog deflector (if being used).
5. Mount the Flush Mount Ring over the Floor Pocket while
aligning screw holes and fasten using screws provided.
The Floor Pocket uses very little compressed air or gas to
operate, a ¼" diameter air supply may be attached to the
Floor Pocket feed hose using the supplied Push Lock connector.
The Floor Pocket operates on 110 vac and opens when power is applied and closes when power is removed.
11
www.ultratecfx.com