Quick Start - DeFelsko PosiTector 6000 Instruction Manual

The PosiTector SmartLink powers-up when the LED button is
pressed. To preserve battery life, the PosiTector SmartLink
powers-down after 5 minutes of no activity. Alternatively, press and
hold the LED button until it turns red and shuts off (approximately
5 seconds).
All probe settings and calibration adjustments (pg 23) are retained
within the PosiTector SmartLink, stored measurement data is
retained within the smart device (cell phone, tablet).
Wirelessly connect the PosiTector probe to the smart device using
the PosiTector App.
Measure
1 Remove the protective plastic cap (if supplied) from probe.
2 Place the probe FLAT on the surface to be measured.
HOLD STEADY. When a valid measurement is calculated,
the LED button flashes green and the measurement is
displayed on the PosiTector App.
3 Lift probe AT LEAST 2 INCHES (5 cm) from the surface
between readings - OR - leave probe on the surface in the
same location for continuous readings.
This continuous reading feature is intended to allow careful probe
placement on small or odd-shaped surfaces. Ignore all readings
taken before the probe is properly placed.
If Memory (pg 13) is ON while continuous readings are being
taken, only the last value on the display (when the probe is lifted)
is stored into memory. Scan Mode (pg 30) stores ALL readings into
memory.
To ensure best measurement accuracy, see Calibration,
Verification and Adjustment (pg 10).

Quick Start

Quick Start
3