Reset Pppoe-Client - HP VSR1000 Layer 2 - Wan Access Command Reference

Default
No PPPoE session is established.
Views
Layer 3 Ethernet interface/subinterface view
Predefined user roles
network-admin
Parameters
dial-bundle-number number: Specifies the dialer bundle number corresponding to a PPPoE session. A
dialer bundle number uniquely identifies a PPPoE session. It can also be used as a PPPoE session ID. The
value range for the number argument is 0 to 1023.
no-hostuniq: Configures the client not to carry the Host-Uniq field in discovery packets. Without this
keyword, the client carries the Host-Unique field. The Host-Unique field uniquely identifies a PPPoE client
when an interface is configured with multiple PPPoE sessions. When the PPPoE server receives a packet
with this field, it must include this field unmodified in the response packet. The device identifies the PPPoE
client where the response packet belongs based on the Host-Unique field in the response packet.
Examples
# Establish a PPPoE session on Layer 3 Ethernet interface Ethernet 1/1.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/1] pppoe-client dial-bundle-number 1

reset pppoe-client

Use reset pppoe-client to reset a PPPoE session corresponding to a dialer bundle.
Syntax
reset pppoe-client { all | dial-bundle-number number }
Views
User view
Predefined user roles
network-admin
Parameters
all: Resets all the PPPoE sessions.
dial-bundle-number number: Specifies a dialer bundle by its number. The value range for the number
argument is 0 to 1023.
Usage guidelines
A PPPoE session in permanent mode and terminated by this command will be established again when
the auto dial timer expires.
A PPPoE session in on-demand mode and terminated by this command will be established again only
when there is a need for data transmission.
Examples
# Reset all PPPoE sessions.
4