L2Tp-Group - HP VSR1000 Layer 2 - Wan Access Command Reference

[Sysname-Virtual-PPP1] l2tp-auto-client l2tp-group 10
Related commands

l2tp-group

l2tp-group
Use l2tp-group to create an L2TP group and enter its view.
Use undo l2tp-group to remove an L2TP group.
Syntax
l2tp-group group-number [ mode { lac | lns } ]
undo l2tp-group group-number
Default
No L2TP group exists.
Views
System view
Predefined user roles
network-admin
Parameters
group-number: Specifies an L2TP group by its number in the range of 1 to 65535.
mode: Specifies a mode for the L2TP group.
lac: Specifies the LAC mode.
lns: Specifies the LNS mode.
Usage guidelines
To create a new L2TP group, you must specify the mode keyword. To enter the view of an existing L2TP
group, you do not need to specify this keyword.
In L2TP group view, you can configure L2TP tunnel parameters, such as tunnel authentication and flow
control.
A device can have L2TP groups in both LAC and LNS modes at the same time, and can have a maximum
number of 1000 L2TP groups.
Examples
# Create L2TP group 2 in LAC mode, and enter its view.
<Sysname> system-view
[Sysname] l2tp-group 2 mode lac
[Sysname-l2tp2]
Related commands
allow l2tp
•
lns-ip
•
user
•
16