L2Tp-Auto-Client - HP VSR1000 Layer 2 - Wan Access Command Reference

undo l2tp enable
Default
The L2TP function is disabled.
Views
System view
Predefined user roles
network-admin
Usage guidelines
L2TP must be enabled for relevant L2TP configurations to take effect.
Examples
# Enable the L2TP function.
<Sysname> system-view
[Sysname] l2tp enable

l2tp-auto-client

Use l2tp-auto-client to trigger an LAC to automatically establish an L2TP tunnel.
Use undo l2tp-auto-client to remove the automatically established L2TP tunnel.
Syntax
l2tp-auto-client l2tp-group group-number
undo l2tp-auto-client
Default
An LAC does not automatically establish an L2TP tunnel.
Views
Virtual PPP interface view
Predefined user roles
network-admin
Parameters
l2tp-group group-number: Specifies an L2TP group whose tunnel parameters are used by the LAC to
establish the tunnel. The value range for the group-number argument is 1 to 65535.
Usage guidelines
The L2TP group specified must be an existing one in LAC mode.
An L2TP tunnel automatically established in LAC-auto-initiated mode exists until you remove the tunnel by
using the undo l2tp-auto-client or undo l2tp-group group-number command.
Examples
# Trigger the LAC to automatically establish an L2TP tunnel by using the tunnel parameters of L2TP group
10.
<Sysname> system-view
[Sysname] interface virtual-ppp 1
15