IKEA VALFRI Manual page 19

ENGLISH
Cleaning the oven door
The oven door has two glass panels. You
can remove the oven door and the internal
glass panel to clean it.
The oven door can close if you
try to remove the internal glass
panel before you remove the
oven door.
Caution! Do not use the
appliance without the internal
glass panel.
1
Open the door fully
and hold the two
door hinges.
3
45°
Close the oven door
to the first opening
position (halfway).
Then pull forward
and remove the
door from its seat.
2
Lift and turn the
levers on the two
hinges.
4
Hold the door trim
on the top edge of
the door at the two
sides and push
inwards to release
the clip seal. Pull the
door trim to the
front to remove it.
5
Hold the door glass
panels on their top
edge one by one
and pull them up
out of the guide.
Clean the glass panel with water and soap.
Dry the glass panel carefully.
When the cleaning is completed, install the
glass panel and the oven door. Do the
above steps in the opposite sequence.
The screen-printing zone must face the
inner side of the door. Make sure that after
the installation the surface of the glass
panel frame on the screen-printing zones is
not rough when you touch it.
Replacing the lamp
Put a cloth on the bottom of the interior of
the appliance. It prevents damage to the
lamp glass cover and the cavity.
Warning! Danger of
electrocution! Disconnect the fuse
before you replace the lamp.
The lamp and the lamp glass
cover can be hot.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box or
deactivate the circuit breaker.
3. Turn the lamp glass cover
counterclockwise to remove it.
4. Clean the glass cover.
5. Replace the oven light bulb with a 25
W, 220 - 240 V (50 Hz), 300 °C heat
19