BELLAGIO
VALVE AND GUIDES COUPLING DATA
CHART (OUTLET)
Specification
Valve guide inside diameter
mm (in)
Valve stem diameter mm (in)
Fitting clearance mm (in)
Checking the cylinder head
Check that:
•
The planes of contact with the cover and with the cylinder are not scored or damaged so as
to compromise a perfect seal.
•
Check that the clearance between the valve guide holes and valve stanchions is within the
prescribed limits.
•
Check the status of the valve seats.
The valve seats should be reamed with a mill. The
seat inclination angle is 45° +/- 5'. After milling, it
is necessary to grind them to ensure a good cou-
pling and a perfect sealing between the ring nuts
and the valve heads.
Installing the valves
NOTE
THE FOLLOWING OPERATIONS REFER TO REMOVING ONLY ONE HEAD BUT APPLY TO BOTH
HEADS.
Desc./Quantity
8.005 ÷ 8.022 (0.3152 ÷
0.3158)
7.965 ÷ 7.980 (0.3136 ÷
0.3142)
0.025 ÷ 0.057 (0.0010 ÷
0.0022)
Engine
ENG - 117