Hilti SB 4-A22 Operating Instructions Manual page 15

5.6 Removing the battery
1. Press and hold down the two release buttons.
2. Pull the battery forward and out of the product.
5.7 Switching on
1. Press the safety lock.
2. Press the control switch.
Note
For safety reasons, the control switch cannot be locked and has to be held down while the tool is
in operation.
5.8 Switching off
WARNING
Risk of injury by saw run-on.
▶ Do not lift the product away from the workpiece until it has stopped completely.
▶ Wait until the product stops completely before you lay it down.
▶ Release the control switch.
5.9 Alignment, workpiece
▶ Bring the workpiece and the bandsaw into alignment.
Note
Incorrect alignment increases the risk of kickback.
Printed: 12.06.2017 | Doc-Nr: PUB / 5310770 / 000 / 01
English 13