Hilti SB 4-A22 Operating Instructions Manual page 14

2. Slacken the 2 screws securing the blade cover and remove the cover.
3. Turn the side handle counterclockwise to unscrew it from the casing of the bandsaw.
4. Pivot the lever in the direction of rotation through its full 180° of travel.
Note
The side handle has to be removed to allow the lever to pivot.
5. Remove the bandsaw blade.
6. Check that the guide grooves are free of foreign matter and clean them if necessary.
7. Remove the rubber ring.
8. Pull the new rubber ring over the roller for the bandsaw blade.
9. Push the rubber ring fully into the guide recess.
◁ The rubber ring lies correctly in the guide recess.
▽ The rubber ring does not lie correctly in the guide recess.
▶ Realign the rubber ring.
10. Slip the bandsaw blade into the blade guides, one after the other. The back of the blade must touch the
bearings in the bottom of the blade guides.
11. Slip the bandsaw blade over both rollers, one after the other.
12. Pivot the lever in the direction of rotation through its full 180° of travel.
13. Check that the bandsaw blade tool is correctly guided over both rollers.
14. Refit the blade cover.
◁ Make sure that the cover is correctly seated.
15. Screw the side handle into the casing of the bandsaw, turning the side handle clockwise.
16. Check that the bandsaw blade is correctly seated by repeatedly switching the bandsaw on and then off
again.
5.5 Inserting the battery
WARNING
Electrical hazard Risk of short-circuit.
▶ Before inserting the battery, check that the battery contacts and the contacts on the saw are free
of foreign matter.
WARNING
Risk of injury Falling battery hazard.
▶ A falling battery could injure you or others. Check that the battery is securely engaged in the
bandsaw.
▶ From the front, push the battery back into the product until it engages with an audible double click.
12 English
Printed: 12.06.2017 | Doc-Nr: PUB / 5310770 / 000 / 01