Hilti SB 4-A22 Operating Instructions Manual page 13

Hide thumbs Also See for SB 4-A22:

1. Slacken the 2 screws securing the blade cover and remove the cover.

2. Turn the side handle counterclockwise to unscrew it from the casing of the bandsaw.

3. Swivel the lever in the direction of rotation through its full 180 ° of travel.

Note

The side handle has to be removed to allow the lever to pivot.

4. Slip the bandsaw blade into the blade guides, one after the other. The back of the blade must touch the

bearings in the bottom of the blade guides.

5. Slip the bandsaw blade over both rollers, one after the other.

6. Swivel the lever in the direction of rotation through its full 180 ° of travel.

7. Check that the bandsaw blade tool is correctly guided over both rollers.

8. Reinstall the blade cover.

◁ Make sure that the cover is correctly seated.

9. Engage the threads of the side handle and turn it clockwise to screw it into the casing of the bandsaw.

10. Check that the bandsaw blade is correctly seated by repeatedly switching the bandsaw on and then off

again.

5.3 Fitting the side handle

CAUTION

Risk of injury Loss of control over the bandsaw.

▶ Use the product only with the side handle fitted. Screw the side handle into the corresponding

tapped hole in the casing.

▶ Fit the side handle.

5.4 Replacing the rubber ring

1. Remove the battery. → page 13

Printed: 12.06.2017 | Doc-Nr: PUB / 5310770 / 000 / 01

English