Table of Contents
Advertisement
Preliminary - Subject to Change Without Notice
6.D.(3) With the shock mounts removed and the tray laying flat
against the mounting structure, center tap four positions
at which the shock mounts will mount to the tray.
6.D.(4) Place each shock mount dead center over each center tap
position.
6.D.(5) Drill two #6 holes per each shock mount.
6.D.(6) Clean and Alodine the mounting surface where the ground
strap will be attached.
6.D.(7) Mount the shocks mounts with two each #6-32 fasteners and
lock-nuts, installing the ground strap under the
appropriate shock mount.
6.D.(8) Attach the mounting tray to the four shock mounts,
installing the ground strap.
6.D.(9) Slide the KRX 1053 Receiver/Exciter into the mounting
tray. Secure the KRX 1053 Receiver/Exciter into place on
the mounting tray with the fluted knob. Provisions for
safety wire installation is provided, if desired.
6.E. Compatible Control Display Unit Installation
For installation information on the PS440, refer to the PS440
Control Display Unit Installation Manual P/N 006-10655-XXXX.
For installation information on the MCDU Multifunction Contol
and Display Unit, refer to Installation Manual P/N: XXXX.
For installation information on the RM-855 Radio Management
Unit, refer to Installation Manual P/N: XXXX.
6.F. Antenna Installation
6.F.(1) Selecting an Antenna Configuration.
While numerous options are available in the choice of
antenna configurations, some configurations will be
better suited for a particular installation than others.
Refer to section 5.B.(7) when selecting an antenna
configuration.
6.F.(2) Refer to section 6.A.(1) for special bonding consideration
when installing an antenna configuration.
Revision 0
10640I00.SLK
N
KHF 1050 SYSTEM INSTALLATION MANUAL
See Section 6.A.(1).
23-10-09
Page 2040
Mar/2003
Hide quick links:
Advertisement
Table of Contents
