Roberts Revival UNO Manual page 14

Your radio has two alarms which can be set to wake you to DAB, FM radio or buzzer alarm. Each alarm can be set to sound once, daily, on weekdays
or at weekends. In the event of a power interruption your radio has a built in memory that will retain your alarm settings. Ensure that the time is set
correctly before setting the alarms. Alarms can be set while the radio is in Standby or switched on.
Note: Alarms cannot be used when the radio is powered from the batteries.
Note: If no buttons are pressed for 10 seconds, your radio will exit the alarm setup.
1. To change the states of the alarms while the radio is in Standby, repeatedly
press the Mode/Alarm button. The display will cycle through No alarm,
Alarm 1 enabled, Alarm 2 enabled or Alarm 1 and 2 enabled.
2. To change the detailed alarm settings while the radio is in Standby,
apply a long press on the Mode/Alarm button. This will cause the
alarms menu to be displayed. Then skip to step 5 below.
3. Alternatively, to change the alarm settings while the radio is switched
on, press Menu.
4. Rotate Tuning until 'ALARM' is displayed. Press Tuning.
5. Rotate Tuning to display either 'ALARM 1' or 'ALARM 2'. Press Tuning
to enter the alarm setting menu.
6. Rotate Tuning to select 'ON' or 'OFF'. If OFF is selected any current
setting for that alarm will be cancelled.
7. With 'ON' selected press Tuning
on the display.
8. Rotate Tuning to choose the desired alarm hour.
13
1 2
DAB
DAB
DAB
DAB