Roberts Revival UNO Manual page 5

1. Plug the mains adaptor into the DC input socket located underneath your
radio (marked 'DC') ensuring that the plug is pushed fully into the socket.
3. Carefully extend the telescopic aerial. The aerial should be fully extended
and positioned vertically for optimum reception.
4. Plug the other end of the mains adaptor into a standard mains socket
outlet and switch on the wall socket. Whenever the adaptor is used the
batteries are automatically disconnected.
5. The display will show 'WELCOME' for a few seconds followed by the clock
with blank digits
DAB radio signal. After a minute or two the current time will appear on the
display.
6. If no signal is found, will continue to be displayed. It may be necessary
to relocate your radio to a position giving better reception. You should then
radio when not in use.
IMPORTANT: The mains adaptor is used as the means of connecting the
product to the mains supply. The mains socket and any multi-way mains block
used for the product must remain accessible during normal use. In order to
disconnect the product from the mains, the mains adaptor should be removed
from the mains socket completely.
Use only the mains adaptor provided with the product, or a genuine replacement
provided by Roberts Radio. The use of alternative adaptors will invalidate the
guarantee.
DC Line Out
7.5V /0.8A
4