Software Version - Roberts Revival UNO Manual

Software version

The software version display cannot be altered and is just for your reference.
1. Press On/Off to switch on the radio.
2. Press Menu.
3. Rotate Tuning until 'SW VERSION' appears on the display. Press Tuning
to display the software version.
4. Press Menu as needed to exit.
The brightness of the display can be adjusted for when the radio is in standby.
If you use the unit in the bedroom, you may prefer a lower standby brightness
level than the standard setting. There are four standby brightness levels.
To change the current standby brightness setting please follow these steps.
1. Press On/Off to switch off the radio.
2. Press the Dimmer button to choose from the High, Medium, Low or almost
Off dimmer setting.
When the radio is in standby pressing any button (except the dimmer button)
or the rotary controls will cause the radio to switch to the 'High' brightness level
for a few seconds. This is so that if the standby brightness level is set to Low
or almost Off, it is still possible to see the time when needed.
When your radio is powered by the AC mains using the supplied mains adaptor
the display backlight will always be on whenever the radio is switched on.
When using the radio powered from the batteries, the display backlight will be
switched on for approximately 12 seconds when any button is pressed.
DAB
DAB
1 2
18