HYT TC700 User Manual page 9

Charging the Battery
When radio LED flashes red and three Beeps sound every 30 seconds after the battery is
installed, that means battery power is low. Please charge the battery.
You are recommended to use HYT-approved, supplied charger; Charger LED will indicate
the charging status.
LED Status
Glow red Charging
Glow green Fully charged
1. Plug the power cable into the adapter.
2. Plug the DC socket of adapter into the DC jack on the rear of the charger.
3. Insert the battery or the radio with battery into the charger cup.
4. Plug the AC socket of adapter into an AC outlet.
5. Make sure that the battery connectors are in contact with the charging terminals; the
charger LED glows red and charging begins.
6. The charger LED glows green when the battery is fully charged in about 3 hours, please
remove the battery or the radio with battery from the charger.
*Notes:
*Charger LED may flash if you connect the charger to power source before inserting the
battery.
9