Squelch Level Check / Adjust Squelch Level; Scan - HYT TC700 User Manual

● Monitor Momentary
Long press the preprogrammed Monitor Momentary key to open the signalling
squelch; release the key to exit.
● Squelch Off
Press the preprogrammed Squelch Off key to open the noise squelch; press the key
again to exit.
● Squelch Off Momentary
Long press the preprogrammed Squelch Off Momentary key to open the noise squelch;
release the key to exit.

Squelch Level Check / Adjust Squelch Level

Long press the preprogrammed Squelch Level Check key to hear the squelch level of the
current channel.
Short press the preprogrammed Adjust Squelch Level key to adjust the squelch level.
Each time when you press the key, a Beep tone sounds, squelch will be increased by one
level (9～0) and the adjusted level is saved.

Scan

Press the preprogrammed Scan key, scan starts from the current channel and ascends
through the channel numbers in scan list. Green LED flashes in scan mode and solidly
glows when a signal is received on a channel and signalling matches. Press the Scan key
again to exit from scan mode.
●
Nuisance Channel Temporary Delete
When scanning stops on a channel, press the preprogrammed Nuisance Channel
Temporary Delete key to temporarily remove that channel from the scan list.
■ A priority channel can't be permanently deleted.
■ You cannot delete a channel if there will be less than 2 channels available for
scanning.
■ To restore the deleted channel back to the scan list, simply exit from scan mode
or switch the radio off and back on.
21