Adjusting Screen Quality - Compaq V1000 User Manual

To maintain the integrity of signal transfers on USB devices, do not use
a cable extender with any USB cables. Low-power USB devices usually
have an attached cable that measures about 3 meters.
Most USB-connected devices will operate with Compaq
computers using Microsoft Windows 95, OSR 2.1. If a USB-
connected device fails to operate, it may require a special
device driver that is not supplied with this version of Microsoft
Windows. Contact your local vendor for driver availability.
Do not daisy-chain a bus-powered device to a bus-powered hub
device that connects to a USB connector on this monitor. For
example, do not connect a mouse to a keyboard that directly
connects to the monitor. The secondary bus-powered device
will not operate. All USB bus-powered devices should be
connected directly to the monitor or to your computer.

Adjusting Screen Quality

Allow the monitor to warm up for 30 minutes before performing the
following procedures. The screen image stabilizes after a warm-up
period.
Optimizing Brightness and Contrast
For best results, set your screen to a dark background (such as the DOS
prompt) before adjusting the following settings:
1. Set the brightness and contrast controls to their lowest settings.
2. Increase brightness until the background portions of the screen
are visible, then slowly reduce brightness until the background is
just extinguished.
3. Adjust contrast control to your preference.
Optimizing Focus
The default image size is preset at the factory. The Size and Position
controls in the on-screen display can be used to increase the screen size
beyond the default setting. However, expanding the screen image
beyond the default settings may degrade the focus at the outer edge of
the screen.
To enhance focus, use the lowest brightness level that gives satisfactory
results in your viewing environment.
Settings that maximize contrast may not offer optimum focus,
and settings that maximize focus may not offer optimum contrast.
1-6 English