Power Cord Set Requirements - Compaq V1000 User Manual

Power Cord Set Requirements

The monitor power supply is provided with Automatic Line Switching
(ALS). This feature allows the monitor to operate on input voltages
between 100-120V or 220-240V.
The power cord set (flexible cord or wall plug) received with the
monitor meets the requirements for use in the country where you
purchased the equipment.
Power cord sets must meet the requirements of the country where you
use the monitor. For more information on power cord set requirements,
contact your Compaq authorized dealer, reseller or service provider.
General Requirements
The requirements listed below are applicable to all countries:
1. The length of the power cord set must be at least 5.00 feet
(1.5 m) and a maximum of 9.75 feet (3.0 m).
2. All power cord sets must be approved by an acceptable accredited
agency responsible for evaluation in the country where the power
cord set will be used.
3. The power cord set must have a minimum current capacity of
10A and a nominal voltage rating of 125 or 250 volts AC, as
required by each country's power system.
4. The appliance coupler must meet the mechanical configuration of
an EN 60 320/IEC 320 Standard Sheet C13 connector, for mating
with appliance inlet on the rear of the unit.
English 1-21