Compaq V1000 User Manual page 5

3. Connect the monitor power cord 1 to the rear panel of the
monitor, then plug the other end into an electrical outlet that is
easily accessible and close to the monitor.
WARNING: To reduce the risk of electric shock or damage to your
!
equipment:
Do not disable the power cord grounding plug. The grounding
plug is an important safety feature.
Plug the power cord into a grounded (earthed) electrical outlet
that is easily accessible at all times.
Disconnect power from the monitor by unplugging the power
cord from the electrical outlet.
Using BNC Connectors
A signal cable with BNC connectors may be used in place of the 15-pin
signal cable to connect the monitor to the computer. To connect two
computers to the monitor, a BNC connector may be used together with
the 15-pin signal cable. If you have separately purchased a signal cable
with BNC connectors, use the following instructions to connect the
signal cable to the monitor.
Plug and play, Fault Management, and AssetControl are not
supported by the monitor when BNC connectors are used.
English 1-3