Using Wps - ZyXEL Communications VMG8924-B10D User Manual

4.3.2 Using WPS

This section shows you how to set up a wireless network using WPS. It uses the VMG as the AP and Zyxel
NWD210N as the wireless client which connects to the notebook.
Note: The wireless client must be a WPS-aware device (for example, a WPS USB adapter or
PCMCIA card).
There are two WPS methods to set up the wireless client settings:
• Push Button Configuration (PBC) - simply press a button. This is the easier of the two methods.
• PIN Configuration - configure a Personal Identification Number (PIN) on the VMG. A wireless client
must also use the same PIN in order to download the wireless network settings from the VMG.
Push Button Configuration (PBC)
Make sure that your VMG is turned on and your notebook is within the cover range of the wireless signal.
1
Make sure that you have installed the wireless client driver and utility in your notebook.
2
In the wireless client utility, go to the WPS setting page. Enable WPS and press the WPS button (Start or
3
WPS button).
Push and hold the WPS button located on the VMG's front panel for more than five seconds.
4
Alternatively, you may log into VMG's web configurator and go to the Network Setting > Wireless > WPS
screen. Enable the WPS function for method 1 and click Apply. Then click the Connect button.
Chapter 4 Tutorials
1
3
VMG8924-B10D/B30D User's Guide
38
2