Sony HVR-Z5C Service Manual page 255

3-28. Relay Gear, Conversion Gear
1. Removal procedure
1) Remove the belt 1 from the conversion gear.
2) Remove the washer 2 from the conversion gear shaft.
3) Remove the conversion gear 3.
4) Remove the relay gear 4.
4 Relay gear
1 Belt
Relay gear
shaft
Conversion
gear shaft
Apply grease when installing
Amount of grease: A ball of
grease of 1.0 mm diameter
HVR-Z5C/Z5E/Z5J/Z5N/Z5P/Z5U
2 Washer
Don't re-use the washer.
3 Conversion gear
Apply grease
Points to be noted
Apply grease
Conversion
gear shaft
2. Attachment procedure
1) Apply grease on the relay gear shaft.
Amount of grease: A ball of grease of 0.5 mm diameter.
2) Apply grease on the conversion gear shaft.
Amount of grease: A ball of grease of 1.0 mm diameter.
3) Install the conversion gear 3 in the relay gear shaft.
4) Install the washer 2 in the conversion gear shaft (Don't re-
use the washer)
5) Hook the belt 1 on the conversion gear and install it while
rotating the conversion gear.
Points
to be noted
Key Points
in Re-assembling
Confirm that the belt doesn't run on the capstan motor block.
Check that the belt has no twisting, dirt, scratches, or grease
splashes when installed.
6-85
Belt
Ensure that belt
has no twisting.
Confirm that the belt does
not run on the capstan
motor block.