NOTE FOR REPAIR
• Make sure that the flat cable and flexible board are not cracked of bent at the terminal.
Do not insert the cable insufficiently nor crookedly.
• When remove a connector, don't pull at wire of connector. It is possible that a wire is snapped.
• When installing a connector, don't press down at wire of connector.
It is possible that a wire is snapped.
NOTE FOR DISCONNECTING THE HARNESS (COAXIAL CABLE)
Harness
(coaxial cable)
HVR-Z5C/Z5E/Z5J/Z5N/Z5P/Z5U
Tweezers etc.
2. DISASSEMBLY
When disconnecting the harness (COAXIAL CABLE), do not
pull the harness part but pull off the connector body with tweezers
etc.
2-1
Cut and remove the part of gilt
which comes off at the point.
(Be careful or some
pieces of gilt may be left inside)