Table of Contents
Advertisement
The settings of SDS200W are separated into seven categories, which are
1. System – to setup the system name and device control.
2. Uplink – to determine wired / wireless relevant parameters. Any change on this
page will take effect after rebooting the system.
3. Console – to change console related settings for POS printers.
4. Utility – to upgrade the firmware version or backup/ restore SDS200W's
configuration settings.
5. Password – to change administrator's password.
6. Reboot – to reboot (restart) the system.
7. Status – to overview device, system, uplink, and radio status if available.
Setting Up SDS200W with the POS Printer
Serial Settings
To make a POS printer properly functions with SDS200W, set up serial settings in
advance in Console on SDS200W's WMI.
Printing On-Demand Tickets for Your Customers
Operators have two ways of printing On-Demand account tickets for their
customers. One is to go onto the WMI of 4ipnet Gateway/Controller and create one
(or more). See the manual of the 4ipnet Gateway/Controller you use; the other is
to use SDS200W by the following two shortcut keys.
(1) 'Number' + ENTER or
(2) 'Number 1' + asterisk (*) + 'Number 2' + ENTER
For example,
'3' + ENTER is to have POS printer print out a billing 3 ticket;
'4' + asterisk (*) + '2' + ENTER allows operator to print a single ticket of billing
plan 4 with two units of the quota. That is, the given quota is multiplied by two.
Note that the keys can only print out tickets one at a time. To Batch-create tickets,
turn to
HSG326 Wireless Hotspot Gateway
109
User's Manual
ENGLISH
Advertisement
Table of Contents
