Component Breakers - Boston Whaler 230 dauntless User Manual

Component Breakers

Your boat has component reset breakers located
on the control station switch panel and on the aft
component board (Figure 4.4.1). The breakers can
be reset if a trip occurs.
If a component breaker trips, determine and correct
the problem before resetting the breaker. Should
a circuit breaker trip repeatedly, have a qualifi ed
electrician determine and correct the cause of the
trip.
Component Reset breakers
Fig. 4.4.1
WARNING
!
Use of higher amperage fuses or breakers is a
fi re hazard.
Use fuses and breakers having the same amperage
rating as the original or as specifi ed.
11
10
1
HORN .......................................................... 3 AMP
2
NAV/ANC LIGHTS ....................................... 3 AMP
3
COURTESY LIGHTS ................................... 3 AMP
4
FRESH WATER PUMP ............................... 10 AMP*
5
CONSOLE LIVEWELL PUMP ..................... 3 AMP
6
RAW WATER PUMP .................................. 15 AMP*
7
ACCESSORY (HELMSEAT LIVEWELL) ..... 3 AMP*
4-4
Section 4 • Electrical System
12
In the event it is necessary to replace a breaker, use
only the same amperage as the original. If a breaker
is replaced with one of lower amperage, it will not be
suffi cient to carry the electrical load of the equipment
it is connected to and will cause nuisance breaker
tripping. Conversely, if a breaker is replaced with
one of higher amperage, it will not provide adequate
protection against an electrical malfunction and will
create a fi re hazard.
1
4
8
8
12V RECEPTACLE ..............................10 AMP
9
TRIM TABS ...........................................10 AMP*
10
MAIN DC BREAKER ............................50 AMP
11
BILGE PUMP (AUTOMATIC) ...............5 AMP
12
STEREO MEMORY ..............................15 AMP
R
TROLL TROLL TROLL TROLL
MODE MODE
- + - +
HORN BILGE NAV/ANC CTSY. LT.
3
2
CONSOLE RAW
FRESH
WATER ACCESSORY
WATER LIVEWELL
6
5 7
RECEPTACLE TRIM TAB
9
* OPTIONAL
230 Dauntless