Table of Contents
Advertisement
CAUTION
!
• NEVER use an open flame in the battery
storage area.
• Avoid striking sparks near the battery.
• A battery will explode if a flame or spark
ignites the free hydrogen given off during
charging.
• ALWAYS disconnect the battery before
doing any work or maintenance on the
electrical system.
• NEVER turn off the battery switches or
disconnect the battery cables while the
engines are running.
Main DC Breaker
The Main DC breaker reset is located on the forward
wall of the console interior. In the event that the main
DC breaker trips, determine and correct the problem
prior to resetting the breaker.
DC Main Breaker Box
Fig. 4.2.1
1
DC BREAKER BOX
2
ELECT. MAIN ............... 30 AMP
3
BILGE ........................... 10 AMP
4
DC MAIN ....................... 25 AMP
CAUTION
!
NEVER reset a breaker without first determining
and correcting the cause of the trip. Should
a circuit repeatedly trip, have a qualified
electrician determine and correct the cause.
4-2
Section 4 • Electrical System
2
4
3
1
Electronics Main breaker
The Electronics Main Breaker is located on the Main
DC Breaker box (See fig. 4.2.1) on the forward wall
of the console interior.
In the event of a loss of power, determine and correct
the problem before resetting the breaker at this
location. Should a circuit breaker trip repeatedly,
have a qualified electrician correct the cause of the
trip.
CAUTION
!
Never reset a breaker without first determining
and correcting the cause of the trip. Should
a circuit repeatedly trip, have a qualified
electrician determine and correct the cause.
Fuse Block
There is an electronics fuse
block located on the aft wall of
the console interior. Power from
the ELEC. MAIN is directed
to the fuse block. The stereo,
VHF radio and the chartplotter
options are protected by fuses
at this location.
In the event you need to replace a fuse, use only the
same amperage as the original. It is recommended
that you carry spare fuses.
If a fuse is replaced with one of lower amperage, it
will not be sufficient to carry the electrical load of the
equipment it is connected to and will cause nuisance
fuse failure or breaker tripping.
If a fuse is replaced with one of higher amperage,
it will not provide adequate protection against an
electrical malfunction and will create a fire hazard.
Component Breakers
Component breakers are located on the helm switch
panel. If a component breaker trips, determine and
correct the problem before resetting the breaker.
Should a circuit breaker trip repeatedly, have a
qualified electrician determine and correct the cause
of the trip.
R
170 Montauk
Advertisement
Table of Contents
