Lanner HCP-72i1 User Manual page 107

Bottom Board Settings:
IIO 0 NTB Config -> NTB to NTB
Primary BAR 23 Size -> 22 (4MB)
Primary BAR 45 Size -> 22 (4MB)
Secondary BAR 23 Size -> 22 (4MB)
Secondary BAR 45 Size -> 22 (4MB)
Crosslink Control -> DSD/USP
Upper Board Settings:
IIO 0 NTB Configu -> NTB to NTB
Primary BAR 23 Size -> 22 (4MB)
Primary BAR 45 Size -> 22 (4MB)
Secondary BAR 23 Size -> 22 (4MB)
Secondary BAR 45 Size -> 22 (4MB)
Crosslink Control -> USD/ DSP
When you finish configurations, go to "Save & Exit" and
select "Save Changes and Exit" option and press the Enter
button. Choose "YES" to confirm for saving your new
configuration and exiting the BIOS setting.
www.lannerinc.com
Kernel
The tests below will be verified by Linux-3.15 version.
Kernel Update
Please issue the following commands accordingly to
upgrade the kernel required:
~# tar xpvf linux-3.15.tar.gz
~# cd linux-3.15
~# patch -p1 < linux-3.15_plx_v02.patch
~# vim driver/pci/probe.c
Then, edit the file of probe.c as follows:
~# make menuconfig
[*] PCI support
[*] Support mmconfig PCI config space access
[*] Networking support --->
Networking options --->
Network testing --->
<*> Packet Generator (USE WITH CAUTION)
Device Drivers --->
[*] Network device support --->
[*] Network core driver support
<M> Virtual Ethernet over NTB
<M> Intel Non-Transparent Bridge support
Note:
1. The value of NTB BAR size in BIOS settings should be
the same as the NTB driver inside of the patch.
2. For the Ivy bridge, all PCIE devices belonging to CPU0
should be set as "MAX payload size=128" when CPU0
enables NTB. The user does not need to set up all PCIE
devices belonging to CPU1 like that, however.
107