AEG BSE774320M User Manual page 48

48 www.aeg.com
Problem
Steam and condensation
settle on the food and in the
cavity of the oven.
The appliance is activated
and does not heat up. The
fan does not operate. The
display shows "Demo".
The descaling procedure is
interrupted before it finishes.
The descaling procedure is
interrupted before it finishes.
There is no water inside the
grill- / roasting pan after the
descaling procedure.
There is dirty water on the
bottom of the cavity after
the descaling cycle.
The cleaning function is in-
terrupted before it finishes.
The cleaning function is in-
terrupted before it finishes.
There is no good perform-
ance of the cleaning proce-
dure.
13.2 Service data
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
The necessary data for the service centre
is on the rating plate. The rating plate is
Possible cause
You left the dish in the oven
for too long.
The demo mode is activa-
ted.
There was a power cut.
The function was stopped by
the user.
You did not fill the water
drawer to the maximum lev-
el.
The grill- / roasting pan is on
a wrong shelf position.
There was a power cut.
The function was stopped by
the user.
You did not remove the side
grids before the start of the
cleaning procedure. They
can transfer heat to the walls
and decrease the perform-
ance.
on the front frame of the appliance
cavity. Do not remove the rating plate
from the appliance cavity.
Remedy
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
Refer to "Basic Settings" in
"Daily use" chapter.
Repeat the procedure.
Repeat the procedure.
Check if the a descaling
agent / water is present in
the water drawer body.
Repeat the procedure.
Remove the residual water
and the descaling agent
from the bottom of the
oven. Put the grill- / roasting
pan on the first shelf posi-
tion.
Repeat the procedure.
Repeat the procedure.
Remove the side grids from
the appliance and repeat the
function.