Key Ignition Switch; Throttle Control - GGP ITALY SPA MP 84 Series Operator's Manual

it outside the side discharge chute.
3. Fit the pin
chute, so that it passes through the coils
of the spring
4. Insert the cotter pin
hole
and cause the pin to fall out
Check that the spring works
correctly and keep the side discharge
chute securely lowered. Make sure that
the pin is fitted properly to prevent
it from falling out accidentally.
4.7
MEANS ASSEMBLY SIDE
SIDE DISCHARGE MODELS
4.8 REAR PLATE ASSEMBLY AND
1.
2.
3.
4.
5.
6.
7.
in the holes on the
and on the side discharge
and the drilled end
in the pin
and rotate the pin
.
5. CONTROLS

5.1 KEY IGNITION SWITCH

1. Stop position.
2. Headlights On position (if
3. On position. All services
are enabled..
4. Start position.

5.2 THROTTLE CONTROL

A. Type "I" with separate Choke
command
B. Type "II"
1. Choke Command - Cold start.
The «CHOKE» position enriches the
1. Maximum engine speed. To
during grass cutting
2. Minimum engine speed. Used
NOTE When moving from one area
to another, put the lever in a position
between «tortoise» and «hare».
EN - 8
10.A
After turning the engine
.
operations.