Digital Operator Keypad Functions; Command Keys - Magnetek GPD 333 Technical Manual

efesotomasyon.com - Yaskawa ac drive,servo motor
Digital Operator Keypad Functions (ref. Figure 2-1):
Mode Selection Key (
PRGM). Active only when GPD 333 is in stopped condition.
Display Selection Key (
change the monitor display selection. In PRGM mode, it
returns to display of presently selected constant.
Read / Write Key (
frequency reference value ( FXXX.X ) into memory. In PRGM
mode, pressing this key recalls and displays constant setting
from memory. Press to enter displayed set value into memory.
Numeral Change Keys (
digit in display:
Digit Selection / RESET Key (
(i.e. blinking) digit in display. Depress key to move one posi-
tion to the right; "wraps around" from far right to far left posi-
tion. This key resets operation of faults, in DRIVE mode only.

Command Keys:

( ): Initiates STOP command (in DRIVE mode).
( ): Initiates RUN command (in DRIVE mode).
( ): Selects FWD or REV run (in DRIVE mode).
( ): Press to change operation from remote to local.
Effective only in DRIVE mode, while in stopped condition.
To disable the LOC/RMT (Local/Remote) key
on the Digital Operator, program any one of
the multi-function inputs, terminals 3, 4, or 5
(constants no-32 , no-33 , or no-34 , respectively)
for data 12 (Local/Remote), and leave that input
terminal open. See page 37.
). Press to change mode (DRIVE or
). In DRIVE mode, press to
). In DRIVE mode, press to enter new
and
^ : Increment by 1
NOTE
19
) change value of blinking
v : Decrement by 1
). Selects "changeable"