Troubleshooting - DeLonghi ETAM29.62 SERIES Instructions For Use Manual

GENERAL ALARM
EMPTY CIRCUIT FILL CIRCUIT
HOT WATER
Press OK
REPLACE FILTER

TROUBLESHOOTING

Below is a list of some of the possible malfunctions.
If the problem cannot be resolved as described, contact Customer Services.
PROBLEM
The coffee is not hot.
The coffee is weak or not creamy
enough.
The coffee is delivered too slowly or a
drop at a time.
Coffee does not come out of one or
both of the spouts.
The appliance does not come on
The infuser cannot be extracted
The inside of the appliance is very dirty.
The water circuit is empty
The water softener filter is exhausted.
POSSIBLE CAUSE
The cups were not preheated.
The infuser has cooled down because
2/3 minutes have elapsed since the last
coffee was made.
A low coffee temperature is set.
The coffee is ground too coarsely.
The coffee is unsuitable.
The coffee is ground too finely.
The spouts are blocked.
It is not plugged into the mains socket. Plug into the mains socket.
The main switch (A16) is not turned on. Press the main switch (fig. 1).
The appliance has not been turned off
correctly
Clean the inside of the appliance thoroughly,
as described in the section "Cleaning" (page
15 If the message is still displayed after cle-
aning, contact a service centre.
Press OK (B1) to deliver water from the spout
(C3) until it flows out normally.
If the problem persists, make sure the water
tank is fully inserted.
Replace the filter or remove it as described in
the section "Water softener filter" (page 18).
SOLUTION
Warm the cups by rinsing them with hot
water (Please note: you can use the hot water
function).
Before making the coffee, heat the infuser by
rinsing using the rinse function (page 10).
Set a higher coffee temperature in the menu
(page 11).
Turn the grinding adjustment dial one click
anticlockwise towards "1" while the coffee mill
is in operation (fig. 11). Continue one click at
a time until coffee delivery is satisfactory. The
effect is only visible after delivering 2 coffees
(see the section: "Adjusting the coffee mill" on
page 13).
Use pre-ground coffee for espresso machines.
Turn the grinding adjustment dial one click
clockwise towards "7" while the coffee mill is
in operation (fig. 11). Continue one click at a
time until coffee delivery is satisfactory. The
effect is only visible after delivering 2 coffees
(see the section: "Adjusting the coffee mill" on
page 13).
Clean the spouts with a toothpick (fig. 26).
Turn the appliance off by pressing the
ton (page 10).
21
but-