Table of Contents
Advertisement
4. As soon as the coffee in the cup reaches the required level,
press the
icon again.
The quantity of coffee in the cup has now been programmed.
Adjusting the coffee mill
The coffee mill is set by default to prepare coffee correctly and
should not require regulating initially.
However, if after making the first few coffees you find that the
coffee is either too weak and not creamy enough or delivery is
too slow (a drop at a time), this can be corrected by adjusting
the grinding adjustment dial (fig. 11).
Please note!
The grinding adjustment dial must only be turned when the
coffee mill is in operation.
If the coffee is delivered too slowly or
not at all, turn one click clockwise to-
wards "7".
For fuller bodied creamier coffee, turn
one click anticlockwise towards "1" (do
not turn more than one click at a time
otherwise the coffee could be delivered
a drop at a time).
These adjustments will only be evident after at least 2 cups of
coffee have been delivered. If this adjustment does not obtain
the desired result, turn the dial another click.
Tips for a hotter coffee
For hotter coffee, you should:
•
perform a rinse cycle by selecting the "Rinsing" function in
the settings menu (page 10);
•
warm the cups with hot water (using the hot water
function);
•
increase the coffee temperature in the settings menu
(page 11).
Making coffee using coffee beans
Important!
Do not use caramelised or candied coffee beans as they could
stick to the coffee mill and make it unusable.
1. Fill the container with coffee beans (fig. 12).
2. Place under the coffee spouts:
- 1 cup, if you want to make 1 coffee (fig. 10);
- 2 cups, if you want 2 coffees (fig. 13).
3. Lower the spouts as near as possible to the cup. This makes
a creamier coffee (fig. 14).
4. Press the icon corresponding to the number of coffees re-
quired (one cup
or two cups
).
5. Preparation begins. The amount of coffee selected is dis-
played together with a progress bar which gradually fills as
preparation progresses.
Please note:
•
While the machine is making coffee, delivery can be inter-
rupted at any moment by pressing any icon.
•
At the end of delivery, to increase the quantity of coffee
in the cup, just press (within 3 seconds) one of the coffee
icons (B6 or B7).
Once the coffee has been made, the appliance is ready to make
the next drink.
Important!
•
Various alarm messages could be displayed while using
the machine (FILL TANK, EMPTY GROUNDS CONTAINER,
etc.). Their meaning is explained in the section "Displayed
messages" (page 20).
•
For hotter coffee, see the section "Tips for a hotter coffee"
(page 13).
•
If the coffee is delivered a drop at a time, too weak and not
creamy enough or too cold, read the tips in the "Trouble-
shooting" section (page 21).
Making coffee using pre-ground coffee
Important!
•
Never place coffee beans in the pre-ground coffee funnel
as this could damage the appliance.
•
Never add pre-ground coffee when the machine is off or it
could spread through the inside of the machine and dirty
it. This could damage the appliance.
•
Never use more than 1 level measure or it could dirty the
inside of the coffee machine or block the funnel.
Please note!
When you use pre-ground coffee, you can only make one cup of
coffee at a time.
1. Press the
icon repeatedly (fig. 8) until "Pre-ground"
is displayed.
2. Open the pre-ground coffee funnel lid (A2).
3. Make sure the funnel is not blocked, then add one level
measure of pre-ground coffee (fig. 15).
4. Place a cup under the coffee spouts ( fig. 10).
5. Press the 1 cup coffee icon
6. Preparation begins. The amount of coffee selected is dis-
played together with a progress bar which gradually fills as
preparation progresses.
Please note!
If "Energy Saving" mode is active, you may have to wait a few
seconds before the first coffee is delivered.
13
(B7).
Advertisement
Table of Contents
Troubleshooting
