Canon CanoScan N650U Getting Started page 53

To Scan Simply by Pressing the Scanner's Start Button
To set ScanGear Toolbox CS to start scanning when the start button is
pushed, perform the following steps in addition to the 5 steps above.
1 Click the [Settings] button on the toolbar to display the ScanGear
Toolbox CS Settings dialog again.
2 Click the [Prefs] tab.
3 Select [Custom1] in the
"When Scanner Push
Button pressed" field.
4 Click the [OK] button.
This will set a scan to be initiated when the scanner's start button is
pressed without requiring any buttons to be clicked on the ScanGear
Toolbox CS toolbar. When the scan is complete, the image will appear
in the PhotoStudio 2000 window.
N650U/N656U/N1220U Getting Started
53