Canon CanoScan N650U Getting Started page 24

○ ○ ○
3. Click the [Start Installation] button at the bottom
right of the window.
This will start the installation of all the application software. You can,
however, control which programs are installed by clicking the check
box beside the name of a program and deleting the [√] check mark
before clicking the [Start Installation] button.
Be sure to install ScanGear Toolbox CS and PhotoStudio 2000 at the
very minimum.
• Do not restart the computer or remove the CD-ROM from the drive
while the installation is proceeding unless so directed by the
CanoScan Setup Utility. These actions would disrupt the installation.
• Do not perform any other operations during the installation.
• Do not click anything other than the specified buttons or items.
○ ○ ○
4. Proceed with the installation by following the
on-screen instructions.
Restart the computer as prompted by the on-screen message after all
the programs have been installed.
○ ○ ○
5. Press the CD-ROM eject button and remove the
CanoScan Setup Utility CD-ROM.
Handle the CD-ROM with care and place it into a protective case.
24
N650U/N656U/N1220U Getting Started
○ ○ ○ ○ ○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○
○
○
○