Regulations And Standards; Ce-Marking - Baxi POWER HT-A 1.430 Installation Manual

2.3 Regulations and standards

2.4 CE-Marking

Beside the general technical rules, the relevant standards, regulations, ordinances
and guidelines should be followed:
- DIN 4109; Noise protection in construction engineering
- DIN EN 12828; Heating plants in buildings
- EnEV - Energy saving regulation
- Federal Immission Control Ordinance 3. BImSchV
- DVGW-TRGI 1986 (DVGW-worksheet G 600); Technical Rules for gas installation
- TRF; Technical Rules LPG
- DVGW-Data sheet G 613 Gas appliances- Installation, maintenance and operat-
ing instructions
- DIN 18380; Heating plants and central hot water plants (VOB)
- DIN EN 12831; Heating plants in buildings
- DIN 4753; Hot water plants for drinking and water supply
- DIN 1988; Technical Rules for drinking water installations (TRWI)
- VDE 0700-102, DIN EN 60335-2-102: Safety of electrical appliances for house-
hold use and similar purposes: Special requirements for gas-, oil- und solid fuel
appliances with electrical connections
- Fuel Ordinance, State Ordinances
- Regulations of the local Electricity Board
- Obligation to register (possibly. Group Exemption Regulation )
- ATV-Code-of-practrice M251 of the waste water technology association
- Regulations of the Public Authorities for the run-off of condensate.
The CE-marking means that the gas-fired fuel value devices meet the require-
ments of the gas devices guideline 2009/142/EG, the low voltage guideline
2006/95/EG, as well as, the guideline 2004/108/EG (electro-magnetic compatibili-
ty, EMV) of the Commission to balance the legal regulations of the member states.
Meeting the protection requirements according to guideline 2004/108/EG is only
guaranteed by operation of the boiler according to purpose.
The ambient conditions according EN 55014 must be met.
Operation is only allowed with correctly fitted casing.
Correct electrical earthing has to be ensured by regular check (e.g. annual inspec-
tion).
When replacing device parts, only original parts as specified by the manufacturer
must be used.
The gas condensing-boilers fulfill the basic requirements of the Efficiency Guide-
line 92/42/EG as condensing boiler.
When natural gas is used, the gas condensing-boiler emit less than 60
corresponding to the requirements as per §6 of the Ordinance regarding small fir-
ing places dated 26.01.2010 (1. BImSchV).
Safety
mg
/ NO
kWh X
7