Toyota Mirai 2017 Owner's Manual page 388

388
8-2. Steps to take in an emergency
13
Inflate the tire until the specified
air pressure is reached.
The sealant will be injected
and the pressure will spike to
44 psi (300 kPa, 3.1 kgf/cm
or bar) or 58 psi (400 kPa,
4.1 kgf/cm
gradually decrease.
The air pressure gauge will
display the actual tire infla-
tion pressure about 1 minute
(15 minutes at low tempera-
ture) after the switch is
turned on.
Inject to specified air pres-
sure.
• Turn the compressor switch
off and then check the tire
inflation
careful not to over inflate,
check and repeat the infla-
tion procedure
specified tire inflation pres-
sure is reached.
• If the tire inflation pressure is still lower than the specified point
after inflation for 10 minutes (40 minutes at low temperature) with
the switch on, the tire is too damaged to be repaired. Turn the
compressor switch off and contact your Toyota dealer.
• If the tire inflation pressure exceeds the specified air pressure, let
out some air to adjust the tire inflation pressure. (→P. 421)
2
or bar), and then
pressure. Being
until the
2