Eco Heat/Cool Mode Operation For Eco Drive Mode; Power Mode Automatic Deactivation; Shifting From P On A Slope - Toyota Mirai 2017 Owner's Manual

Regenerative Braking
■
When the shift position is in D, regenerative braking is engaged when the foot
is released from the accelerator pedal.

ECO HEAT/COOL mode operation for Eco drive mode

■
When the ECO MODE switch is pressed, the system switches over to ECO
●
HEAT/COOL mode. (→P. 263) During the use of Eco drive mode, only the
ECO HEAT/COOL mode can be canceled.
When it is desired to improve the effectiveness of the air conditioning sys-
●
tem, perform the following operations.
• Adjust the temperature settings and airflow mode.
• Press
cel the ECO HEAT/COOL mode, or cancel Eco drive mode.

Power mode automatic deactivation

■
Power mode is automatically deactivated if the power switch is turned off after
driving in power mode.

Shifting from P on a slope

■
When changing to another position from P when parked on a slope in the P
position, vibrations may be felt.
WARNING
When driving on slippery road surfaces
■
Do not accelerate or shift the shift position suddenly.
Sudden changes in regenerative braking may cause the vehicle to spin or
skid, resulting in an accident.
For the shift lever
■
Do not remove the shift lever knob or use anything but a genuine Toyota
shift lever knob. Also, do not hang anything on the shift lever.
Doing so could prevent the shift lever from returning to position, causing
unexpected accidents to occur when the vehicle is in motion.
P position switch
■
Do not press the P position switch while the vehicle is moving.
If the P position switch is pressed when driving at very low speeds (for
example, directly before stopping the vehicle), the vehicle may stop sud-
denly when the shift position switches to P, which could lead to an accident.
of the air conditioning operation panel (→P. 258) and can-
5-2. Driving procedures
183
5