Setting The Water Level; Testing The Drain Valve; Refitting The Pad Frames - Seeley EXQ Installation Manual

SETTING THE WATER LEVEL

Isolate power to the cooler electronics and disconnect the
pump, making sure the plug is kept away from any water. Turn
the power back on.
Turn on the mains water supply to the cooler.
Turn the cooler on at the controller, in "COOL" mode.
Adjust set temperature slider / fan speed buttons to be close to
current room temperature so that fan speed remains low.
Allow the tank (reservoir) to fill with water. The float valve will
eventually stop the water from entering the cooler. Wait for this
to happen and check the water level.
If the level is too high rotate the float clockwise. Drain some water
from the tank and allow it to refill to the new set point. If too low
rotate the float in an anti-clockwise direction.
|
14
ILL1663-A
ILL2117-A
ILL1615-A
ILL2118-A
ILL1370-B
SETTING THE WATER LEVEL cont.
For EXQ, EXS model the correct water level is approximately
5mm above the surface of the tank the float valve is mounted on.
For EZQ models the water level is at the moulded triangle shape
marking on the tank.
EXQ/EXS MODEL
EXTRA NOTES FOR EZQ MODEL ONLY
6.5mm
6.5mm
Look for a moulded triangle shape marking in the tank.
It is advisable to check the water level again after the float valve
washer has "bedded in".Once the water level is correct, isolate
the control box and connect the pump plug.

TESTING THE DRAIN VALVE

With the wall control in "OFF" mode, press and hold the
and buttons together for 1 second on the MagIQcool
controller, "dr" is displayed and the drain valve will open.
Select the "SETTINGS" mode on the MagIQtouch Controller
and select the "COOLER" sub-heading. Select the "MANUAL
DRAIN" option to operate and test the drain valve.

REFITTING THE PAD FRAMES

Refit the pad frames by locating the bottom edge in the tank
groove, then push the top in under the lid.
Refit the corner clips after replacing the pad frame(s).
2
1
ILL526-C
ILL1656-A
A294-B
3
ILL1600-A