Sharp AR-F15 Service Manual page 200

CHAPTER 5 MECHANICAL CONSTRUCTION
3. Removing the Scrap Full Detector
PCB Unit
1) Remove the right guide assembly (see III-
A-1).
2) Remove the screw [1], disconnect the con-
nector [2], and remove the scrap full detec-
tor PCB unit [3].
4. Removing the Punch Driver PCB
1) Remove the puncher unit from the finisher.
2) Remove the four screws [1], disconnect four
connectors [2], and remove the punch driver
PCB [3].
5-44
[1]
Figure 5-328
[3]
[1]
[2]
Figure 5-329
[3]
[2]
[1]
[2]
[1]