Air And Material Controls - WAGNER flexio 690 Owner's Manual

Spray performance will depend upon a number of
factors: material thickness, spray pattern selected,
material volume, and air pressure. With any type
of air-assisted spraying, desired spray results will
be achieved through some trial and error while
adjusting some or all of these variables.
Review these pages to learn about the spray controls
and how they can be used to acheive the desired
spray results.
X-Boost™ Power Dial
The X-Boost™ power dial adjusts the level of air
pressure produced by the turbine. The X-Boost™
power dial is factory-set at maximum out of the box.
• A high air power level will result in faster
coverage and a smoother finish with thicker
materials.
• Lowering the air power will result in larger
drops of material being sprayed from the gun,
and will create a slightly rougher finish.
+
Tip: The thicker the material you are spraying, the
higher the turbine power you will need.
Tip: For fine-finish work with thinner materials, you
may want to decrease the air power. Spraying a
thinner material at high air power will result in more
overspray. Overspray is sprayed material that does
not stick to the spray surface and bounces back.
Power and Material Settings Guide
Coating
Transparent / semi-transparent
stains, sealers
Lacquers (water based)
Solid stains
Polyurethane
Oil enamels
Latex paints plus primers, Latex
paints
Oil or latex primers
English
8

Air and Material Controls

-
Material Flow
Light
Light
Med
Med
Heavy
Heavy
Heavy
Material Flow Adjustment
The material flow adjustment controls the amount
of spray material that is sprayed from the spray gun.
• For thicker materials, it is recommended that
you start with the highest material flow setting
and then gradually decrease the flow to suit
your particular spraying needs.
• For thinner materials, it is recommended that
you start with a low material flow setting, and
then gradually increase the flow to suit your
particular spraying needs.
• The higher the flow setting, the quicker you will
have to work in order to avoid drips and sags in
your spray pattern.
Set the material volume by turning the knob on the
trigger of the spray gun.
Tip: Spraying with the control set too high will
result in a spray pattern that runs and sags (too
much material).
Tip: Spraying with the control set too low will result
in a spray pattern that does not cover (not enough
material).
Tip: To ensure desired results are achieved with the
controls, test your spray pattern on the spray poster
or a scrap piece of wood or cardboard.
iSpray nozzle
air Power
Low
Low
Low / Med
Low / Med
Med
Med-Hi
Med-Hi
Detail Finish nozzle
Material Flow
Med/Heavy
Med/Heavy
Med
Med/Heavy
Heavy
N/A
N/A
© Wagner Spray Tech - All Rights Reserved
air Power
Low
Low
Low / Med
Low / Med
Med-Hi
N/A
N/A