Material Preparation - WAGNER flexio 690 Owner's Manual

note: Material to be sprayed may need to be strained
to remove any impurities in the paint which may enter
and clog the system. Impurities in the paint will give
poor performance and a poor finish.
note: Only thin the material if absolutely necessary to
improve spray performance (or if advised by coating
manufactuer). Optimal spray performance should be
acheived simply by adjusting the various controls on
the unit.
To Prepare the Material:
1. Stir the spraying material thoroughly.
2. Unscrew the cup from the nozzle.
3. After the material has been properly thinned and
strained, fill the container to desired level.
Thinning the material:
For certain spraying situations or desired finishes,
thinning the material may be desired. It is not necessary
for most materials when used with the iSpray nozzle.
For use with the Detail Finish nozzle thinning may be
needed to acheive a finer finish. Make sure you adjust
the X-Boost™ and Material flow settings for your specific
material needs.
If thinning is necessary, use the proper solvent as
specified by the material manufacturer. Never exceed
the thinning advice given by the coating manufacturer.
Do not thin with materials that have
a flashpoint below 100°F (38°C). The
material flashpoint should be shown on
the material container.
© Wagner Spray Tech. - All Rights Reserved

Material Preparation

1
2
3
English
5