Table of Contents
Advertisement
S
S
UPER
ERVER 5018R-M/5018R-MR User's Manual
Power Supply*
*Note: the 5018R-MR features redundant power supplies (two power supply mod-
ules).
6-2
Control Panel
The control panel (located on the front of the chassis) must be connected to the
JF1 connector on the serverboard to provide you with system control buttons and
status indicators. These wires have been bundled together in a ribbon cable to
simplify the connection.
The LEDs inform you of system status. See Chapter 3 for details on the LEDs and
the control panel buttons. Details on JF1 can be found in Chapter 5.
6-3
Accessing the System
Removing the Chassis Cover
1. Power down the system and unplug the power cord from the rear of the
power supply.
2. Simultaneously press both release tabs.
3. Slide the cover back toward the rear of the chassis.
4. Lift the cover upwards and off of the chassis.
Warning: Except for short periods of time, do NOT operate the server without the
cover in place. The chassis cover must be in place to allow proper airflow and prevent
overheating.
Figure 6-1. Chassis Front and Rear Views
USB Ports
SATA Drives (4)
I/O Ports
COM2 Port
PCI Expansion Slot
6-2
Control Panel
Advertisement
Table of Contents
