Table of Contents
Advertisement
Fig. 176 Replacing the bulb in the headlight.
Please first read and note the introductory information and heed the WARNINGS
Please carry out each step only in the order specified:
Front turn signal ⇒
1.
Starting at the inside, pull the cover forward slightly by the fins until the retainers release
2.
3.
Pull the cover out of the side mounts in the direction of the arrow (B).
4.
Remove the screws
5.
Tilt the light forward slightly and remove it from the side mounts ⇒
6.
Release the connector
7.
Turn the bulb holder
the arrow until it stops and remove it toward
the rear with the bulb.
8.
Replace the burned out light bulb with a new bulb of the same type.
9.
Insert the bulb holder in the headlight and turn it all the way to the right.
10.
Attach the connector
(2). The connector must latch with a "click."
11.
Insert the lights into the mounts (small arrows) and tilt them back.
Tighten the screws ⇒
12.
Beginning at the outside, insert the cover into the bumper opposite the direction of the
13.
The illustrations show the left headlight. The right headlight is the mirror image.
Different models may have different lights, and the location and design of covers, bulb holders,
and bulbs may be in a different location than shown in the illustrations.
Fog light / cornering light
f ig. 176 (2)
Please review and follow the checklist.
⇒
f ig. 175
(arrow (A)).
(1)
and
(2)
using the screwdriver in the vehicle tool kit
(1)
and disconnect it. Release the connector
(2)
in the direction of
Turn the bulb holder
the arrow until it stops and remove it toward
(1)
to the bulb holder
Attach the connector
(4). The connector must latch with a "click."
f ig. 175 (1)
and
(2)
arrow (B).
.368.
(4)
f ig. 176
(small arrows).
(3)
and disconnect it.
(4)
in the direction of
the rear with the bulb.
(3)
to the bulb holder
with the screwdriver.
Advertisement
Table of Contents
