40
GFK-2847F
For public disclosure
4.7.2.2 Setting an IP Address
The QuickPanel
+
Operator Interface provides two methods to set an IP address:
•
DHCP (Dynamic Host Configuration Protocol)
The network server assigns an IP address during QuickPanel
must be connected to the network.) There must be a DHCP server on the connected
network for a valid IP address to be assigned. Contact your network administrator to
ensure correct DHCP server configuration.
Manual Method
•
Specify the numeric addresses obtained from your network administrator for the
+
QuickPanel
IP Address, Subnet Mask and Default Gateway (if applicable).
Note Run the
Backup utility
4.7.3 Serial Port
4.7.3.1 IC755CxW07CDx Serial Port Details
•
A terminal block is supplied.
•
The mating terminal block supports stranded 30-14 AWG (0.05 – 2.00 mm
•
At a minimum, the cable must be rated for 75°C (167 °F) or more.
•
Secure the serial cable to the mating connector while noting signal orientation and
tighten the screw clamps.
•
The torque for the attaching screws is 0.3 Nm (2.66 in-lb).
Interface: x1 RS-232
Connectors: Euro Terminal (Tyco Electronics 284539-5)
Mating Connector: (Tyco Electronics 284510-5)
Pin #
Signal Name
1
TXD
2
RXD
3
RTS
4
CTS
5
SGND
to save the settings.
COM1 Pin Details
5
QuickPanel+ Operator Interface User Manual
+
initialization. (You
2
) wires.
Pin-out
1