Removing The Lower Anchor Connectors; Installing The Optional Accessories - Evenflo Tribute Owner's Manual

3
WARNING
C
Removing the Lower Anchor
Connectors
The Lower Anchor Connector that comes with
1
your child restraint will be one of the two types
below.
A
Tilt the adjuster and
A
slide the strap to loosen.
2
Arrow MUST be level
with ground when used
Rear-Facing
REAR OF VEHICLE
To remove the hook
B
remove from anchor
D
44
• To avoid a strangulation
hazard, you MUST
roll or fold excess tether
strap and secure with the
strap/rubber band.
• Attach the tether hook
to the storage clip when
not in use. This will keep
an unused tether or tether
hook from hitting someone
during a crash.
B
Press the adjuster release
button to loosen.
B
B
D
C
, press the tab and twist, then
C
.
3
tightly
C
1
B
2
Note: The optional Infant Head Support and Body
Pillow are for Rear-facing use only.
Note: Attach Infant Head Support through harness slots
just above harness straps.
When the Lower anchor
connector assembly is not
B
in use you
the hooks
of the child restraint.
A loose Lower anchor
connector assembly strap
and hook may injure your
child.

Installing the Optional Accessories

Not available on all models. Styles may vary.
To install the cup holder
peel back the seat pad
and insert the hook on the
cup holder into the slot in
seat, as shown. Replace pad
over the seat.
A
Not available on all models. Styles may vary.
The optional Body Pillow
when placed in the restraint,
D
as shown, helps support your
child.
The optional Infant Head
Support
D
C
against the seat back, as shown.
Be sure to cut off the plastic
attachment between the head
support and the seat pad. Small
parts may be a choking hazard.
MUST attach
to the back
B
A ,
B
,
C
should lie flat
45