Forward-Facing Installation With; Lower Anchor Connectors - Evenflo Tribute Owner's Manual

Up to 18kg
Hide thumbs Also See for Tribute:
Table of Contents

Advertisement

Positioning the Recline Stand for
Forward-facing Use
A
Forward-facing Upright
The child restraint
MUST
forward-facing use.
Child
MUST
weigh 10 – 18 kg (22 – 40 lbs) and be at
least 2 years old.
30
Lift the child restraint and
flip the recline stand
toward the rear, as shown,
to the upright position.
be in the upright position for

Forward-facing Installation with

LATCH is a system for attaching the child restraint to your
vehicle seat. It is to be used in place of your vehicle's seat
belts and can be used in vehicles with LATCH anchors.
A
NOT
install this child restraint with LATCH and the
vehicle's seat belts. Your vehicle owner's manual may
refer to this system as ISOFIX, Universal Anchorage
System (UAS), or Lower Universal Anchorage System.
• To avoid a strangulation hazard, you
unused lower anchor connector assembly, with all slack
removed, in storage area on the back of the seat
(page 45). Roll or fold excess lower anchor connector
strap and secure with a rubber band to prevent serious
injury to vehicle occupants.
1
DO NOT
forward-facing. The harness may not properly
restrain the child in the event of a crash.

Lower Anchor Connectors

WARNING
MUST
WARNING
use the lowest set of harness slots
Make sure that
A
the harness straps
are in one of the
three upper strap slots
harness straps
MUST
shoulder height or above, using
the strap slots closest to your
child's shoulders
plate is attached to the bottom
of the harness strap in the child
B
position
(page 40). This will
B
provide more room for your child
to fit comfortably.
DO
store the
C
. The
A
start at
. The splitter
C
31

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

SonusSonus 65

Table of Contents