Installing Child Restraint Forward-Facing In Aircraft; Care And Cleaning - Evenflo Tribute Owner's Manual

Installing Child Restraint
Forward-facing in Aircraft
3
Fasten the aircraft seat belt
4
The aircraft seat belt must be as tight as possible. Route the
excess aircraft seat belt strap
facing belt path opening, as shown above. Using your
B
full weight, push the child restraint firmly onto the aircraft
seat while pulling on the excess seat belt strap to tighten.
Note: Because of the fixed length of aircraft seat belts, the belt
buckle could be behind the child's back after tightening the
belt. For your child's comfort, Evenflo recommends cushioning
the child's back by placing a small pillow or folded-up blanket,
or a folded-up jacket, over the belt buckle.
Check your work. Reconnect the seat pad to the front
of the child restraint. Try to move the child restraint in all
directions. If you can move the restraint more than 25 mm
(1 in.) from side to side or front to back at the forward-
facing belt path, the aircraft seat belt is not tight enough,
and you MUST install again until the seat belt is tight.
50
A
.
A
B
C
back through the forward-
C
• DO NOT lubricate or immerse in water the LATCH
connectors, the buckle, or any other part of this child
restraint, unless rinsing is permitted, as stated on the back
of the buckle for your restraint.
• Plastic and metal parts may be wiped clean with mild
soap and water and dried with a soft cloth. Do not use
abrasive cleaners or solvents.
• Take care not to damage any labels.
• The harness can be wiped clean with mild soap and
water. Allow harness to air dry.
• Machine wash the seat pad separately in cold water,
delicate cycle. Tumble dry 10 to 15 minutes on low
heat.
• NEVER use child restraint without the seat pad.
• To protect the child restraint from damage caused by
weather, rodents, and other elements common to
garages, the outdoors, and other storage locations,
remove the seat pad and thoroughly clean the
restraint and pad prior to storage. Take care to clean
in the areas where crumbs and other debris tend to
accumulate.
T
T
IP
IP
Proper Disposal of This Child Restraint
At the end of this child restraint's useful life, Evenflo
encourages you to dispose of it properly. Most of the
components in this child restraint are recyclable.
1. Remove all fabric and padding.
2. Remove all screws and disassemble the restraint.
3. Recycle all plastic/foam parts and discard the rest.
If your local recycling center won't accept the padding,
you may dispose of it in the landfill.
NOTE: Evenflo uses recycled materials in the
manufacturing process whenever possible but never for
components that are critical for safety.

Care and Cleaning

!
!
To help protect the
vehicle upholstery, place a
towel beneath and behind
the child restraint.
51