Installing Child Restraint Rear-Facing In Aircraft - Evenflo Tribute Owner's Manual

Installing Child Restraint Rear-facing
in Aircraft
4
A
Fasten the aircraft seat belt
5
D
A
The aircraft seat belt
A
the excess seat belt strap
belt path opening, as shown above. Using your full
B
weight, push the child restraint firmly onto the aircraft
seat while pulling on the excess seat belt strap to tighten.
Check your work. Reconnect the seat pad to the front of
the child restraint. Try to move the child restraint in all
directions. If you can move the restraint more than
25 mm (1 in.) from side to side or front to back at the
rear-facing belt path
B
tight enough, and you
belt is tight.
48
.
A
B
must be as tight as possible. Route
back through the rear-facing
D
, the aircraft seat belt is not
A
MUST install again until the seat
Installing Child Restraint
Forward-facing in Aircraft
IMPORTANT: Before installing the child restraint, make
sure the aircraft seat is in a fully upright position.
1
Aircraft
Seat Belt
Adjust the child restraint to its upright position (page 30),
then place it on the aircraft seat forward-facing, as shown
above.
2
B
A
Route the aircraft seat belt
forward-facing belt path opening in the back of the child
restraint and continue through the belt path opening
on the opposite side of the child restraint.
Note: Lift the restraint's seat pad away for easier access.
through the
A
B
49