Rear-Facing Installation With Seat Belt; Forward-Facing Use - Evenflo Tribute Owner's Manual

6
WARNING
DO NOT use this child restraint if it moves more than
25 mm (1 in.) side-to-side or front to back at the
rear-facing belt path. Serious injury or death may result
from poor installation. If you can not tightly secure the child
restraint, try again or move it to another location, or install
with the vehicle seat belt.
Using your full weight, push the child restraint firmly into
the vehicle seat while pulling up on the lower anchor
connector assembly strap to tighten.
The lower anchor connector assembly strap must be as
tight as possible.
If you can move the child restraint more than 25 mm
(1 in.) side to side or front to back at the rear-facing belt
path , the lower anchor connector assembly strap is not
F
tight enough. You will need to try again, find another
location for your child restraint, or install with the vehicle
seat belt (page 23). To remove the lower anchor connector
assembly strap, go to page 44.
22
F

Rear-facing Installation with Seat Belt

forward-facing with an infant
weighing less than 10 kg (22 lbs).
Crash forces may cause serious
For complete child requirements for
forward-facing use, see page 2.
Infants
facing the rear of the
vehicle. Adjust the child
restraint to the recline position
(page 18). Place the child
Arrow MUST be level
with ground when used
Rear-Facing
REAR OF VEHICLE
restraint in your vehicle rear-
facing.
1 WARNING
Make sure both harness straps are installed
completely on the splitter plate, as shown.
Failure to properly attach the harness straps to the
splitter plate may result in a loose harness and serious
injury or death to your child.
WARNING
NEVER
turn a child restraint
injury or death.
MUST always ride
Attach the harness straps
to the splitter plate using
B
the infant position (page 40)
on the harness straps.
As your child grows, you can
attach the harness straps
to the splitter plate using the
pockets at the end of the
straps.
B
A A
A
A
23