Subaru LEGACY 2003 Service Manual page 130

DIAGNOSTICS CHART WITH DIAGNOSIS CONNECTOR
VDC (DIAGNOSTICS)
7 CHECK GROUND SHORT OF HARNESS.
1) Turn ignition switch to OFF.
2) Disconnect connector from VDCCM.
3) Measure resistance between VDCH/U con-
nector and chassis ground.
Connector & terminal
(F91) No. 13 — Chassis ground:
(F91) No. 14 — Chassis ground:
Does the measured value exceed the spec-
ified value?
8 CHECK BATTERY SHORT OF HARNESS.
Measure voltage between VDCH/U connector
and chassis ground.
Connector & terminal
(F91) No. 13 (+) — Chassis ground ( − − − − ):
(F91) No. 14 (+) — Chassis ground ( − − − − ):
Is the measured value less than the specified
value?
9 CHECK BATTERY SHORT OF HARNESS.
1) Turn ignition switch to ON.
2) Measure voltage between VDCH/U con-
nector and chassis ground.
Connector & terminal
(F91) No. 13 (+) — Chassis ground ( − − − − ):
(F91) No. 14 (+) — Chassis ground ( − − − − ):
Is the measured value less than the speci-
fied value?
10 CHECK OUTPUT VOLTAGE OF PRESSURE
SENSOR.
1) Turn ignition switch to OFF.
2) Disconnect connector from VDCCM.
3) Remove cover from VDCCM. <Ref. to
VDC-19, REMOVE, VDCCM Connector
Cover.>
4) Connect connector to VDCCM.
5) Connect all connectors.
6) Turn ignition switch to ON.
7) Do not depress brake pedal.
8) Measure voltage between VDCCM connec-
tor terminals.
Connector & terminal
(F87) No. 77 (+) — No. 76 ( − − − − ):
(F87) No. 36 (+) — No. 76 ( − − − − ):
Is the measured value within the specified
range?
11 CHECK BRAKE FLUID LEAKAGE.
Inspect fluid leakage between brake master
cylinder and VDCH/U.
Does brake fluid leak?
12 CHECK BRAKE MASTER CYLINDER.
Inspect brake master cylinder hydraulic pres-
sure. <Ref. to BR-36, OPERATION CHECK
(WITH GAUGES), INSPECTION, Brake
Booster.>
Is hydraulic pressure normal?
Step Value
1 MΩ
0.5 V
0.5 V
0.48 — 0.72 V
Fluid leaks.
Normal.
VDC-128
Yes
Go to step 8. Repair harness
between VDCH/U
and VDCCM.
Go to step 9. Repair harness
between VDCH/U
and VDCCM.
Go to step 10. Repair harness
between VDCH/U
and VDCCM.
Go to step 11. Replace VDCH/U.
<Ref. to VDC-8,
VDC Control Mod-
ule (VDCCM).>
Retighten or Go to step 12.
replace.
Go to step 13. Replace master
cylinder.
No